BLC8610 Explosion-proof road lamp | Explosion-proof lights | explosion-proof horse lights | explosion-proof platform lamp 

 Overview: 
 Applicable to the petroleum, chemical and other flammable and explosive places for road lighting. 
 A performance: 
 The highest / Flameproof explosion-proof level, can be used in a variety of flammable and explosive safety. 
 / Efficient HPS twin-tube gas discharge lamp as the light source, through the fog, the long life of 50,000 hours; intelligent circuit design, the lamp instant start, without cooling. 
 / High-tech surface coating treatment, rain and corrosion resistance, never rust; transparent parts using the latest photocatalyst nano-materials, it can automatically decompose stains, sticky oil to ensure that the brightness of the lamp lighting. 
 / Case selection of a special alloy of high hardness, multi-damping structure, with a strong shock and impact resistance, can be used in outdoor harsh environments and long-term. 
 Two use: 
 1, the lamp is equipped with cable penetration pole, then the lamp on in φ60mm the pole through the compression ring sets, adjust the lighting direction, tighten the hold-down ring on the bolt fixtures will be fixed. 
 2 Explosion-proof ballast box into the base of the pole the bottom, open the ballast cover and then unscrew the compression nut of the introduction of the mouth, lighting and cable wear into the ballast box wiring. Note: The red line is connected to the terminal block on the 4th end, the black wire connected to the terminal block on the 5th end, yellow-green wire connected to the ground on the 6th. 
 3, loosen the ballast box to another introduction of the compression nut of the mouth of the input power cord to penetrate the ballast box wiring. Note: FireWire connected to the No. 1 side, the zero line connected to the terminal on the 2nd, the ground wire on the ground. When the wires all connected, then ballast box on the compression nut tightened, covered with ballast box and above the bolts tightened, cited a ground wire is connected to the ground terminal of the ballast outside the and it works. 
 Three note: 
 Open the lamps must be powered down. 
 2, open lamps must use special tools. 
 Four technical parameters: 
 Rated voltage: 220VAC 50Hz 
 Protection of enclosure: IP65 
 Inlet thread: G3 / 4 
 The introduction of cable: φ8 ~ φ14mm 
 Dimensions: 540 × 364 × 192mm 
 Total weight: 11Kg 

 The company specializes in the production of explosion-proof distribution box, explosion-proof control box, explosion-proof power overhaul box Explosion-proof control box operation column, Explosion-proof explosion-proof lights, glare floodlights NFC9180 infield light Explosion-proof Pan light BFC8120, one BAD81 series of explosion-proof lights, explosion-proof discharge lamp, LED Explosion-proof floodlights, explosion electromagnetic starter, explosion-proof cable tray, explosion proof junction boxes, explosion-proof fluorescent lamp, explosion-proof anti-corrosion plastic fluorescent specifically for explosion-proof emergency lights, explosion-proof marker lamps, explosion-proof safety exit lights, YK40-1X2L energy efficient one leg dedicated electronic ballasts, YK36DF-2CS explosion-proof electronic ballasts, YK40-1DFL type of energy-efficient one leg electronic ballasts, JLY-D continuous metal halide lamp controller, YK20-1DFL type of leg-specific energy-efficient electronic ballasts -1 YK36DF × 2CS explosion-proof electronic ballasts, explosion-proof marking lights, emergency power, explosion-proof emergency light emergency power, explosion-proof air conditioners, explosion-proof hose, explosion-proof connector. . . . Welcome to consult ! !